AUTONET TV

A Not-So-Straight Story (Vehicle Pulls to One Side)

A vehicle should travel straight down a straight road with the steering wheel centered.  But time and travel can take their toll and soon you may find your vehicle pulling to the left or right.  Those are not good signs and should be taken care of fairly quickly.

One thing that you should note is when this is happening: if it is all the time, only when you brake, only when you accelerate. If you describe these symptoms to the service adviser or technician, it may help them pinpoint the cause more quickly. 

Many things can cause a vehicle to pull to one side, one of which is that it's out of alignment.  If so, you could be doing damage to other components of your vehicle if you keep driving with it this way. If your tires show signs of uneven wear on the treads or if your wheels squealing, that is another clue.

Improperly inflated tires can also cause your vehicle to pull in one direction.  Your service facility can check to see if your tires have the pressure recommended by your vehicle's manufacturer. 

When steering linkage wears out or a wheel bearing goes bad, both of those can cause a vehicle not to track straight. When components age and loosen up, they can present a safety hazard and premature tire wearing. 

Maybe you notice the pulling only when you are braking.  That points to a failure of your braking system, perhaps a sticky brake caliper.

When your vehicle was brand new, it went straight unless you guided it on a different path. It's best to have it checked out if it is showing some of these symptoms.  It could save you money in the long run and you'll be driving a safer, better performing vehicle.  That's what they mean by steering you right!

Corporate Autoworks
5195 Harvester Rd. Unit#1
Burlington, ON L7L 6E9
905-333-9201
http://www.corporate-autoworks.com

Differential Essential (Differential Fluid Exchange)

What's the dif? To an automotive technician, it's the differential, a part of your vehicle that helps direct power from the engine to the wheels.  The differential is a gearbox that enables the drive wheels to turn at different speeds (they do that when you turn).  

Inside the differential is a fluid that makes sure those gears and other parts are lubricated since there are a lot of metal moving parts in there.  (Your vehicle may have more than one differential in it depending on the drivetrain.) 

As you can imagine, it's important that the lubricant in those differentials do its job.  Otherwise, the gears may be damaged by heat and friction. The more you drive your vehicle, the more likely it is for that lubricating fluid to break down.

So, it's important to have the differential fluid exchanged every so often.  Your vehicle's manufacturer recommends how often your model should have that done, but a common interval is every 30,000-60,000 miles/50,000 km-100,000km.  Regular exchange of differential fluid can reduce premature wear of the gears inside.

Scheduled maintenance goes a long way to preventing differential problems, but sometimes when they begin to fail, you may hear the vehicle sounding a little louder than usual where the differentials are located.  

When it comes to changing the differential fluid, some have a drain plug in them. Others require the entire cover to be removed to drain the fluid.  There are often gaskets that must be changed at the same time to make sure there are no leaks.
Now when someone asks you, "What's the dif?" You’ll know how essential the differential is and how to keep it running in top shape.

Corporate Autoworks
5195 Harvester Rd. Unit#1
Burlington, ON L7L 6E9
905-333-9201
http://www.corporate-autoworks.com

It's Brake Time (Brake Calipers)

Race car drivers have demonstrated the advantages of disc brakes, so most modern vehicles use them.  Sometimes just the front wheels have disc brakes, but many vehicles now have them all the way around. 

A major component of the disc brake is called a caliper.  It works by squeezing brake pads against the disc or rotor, kind of like a bicycle hand brake.  The brake pads themselves are what contact the rotor, causing friction to build and the wheel to slow down, but it's the calipers that apply the pressure to the pads.

Caliper design has evolved over the years, and there are two common types.  One is called a floating caliper.  It has one or two pistons on one side of the disc. When you push down the brake pedal, the piston or pistons in your caliper put pressure on that one side.  A mechanism connected on the other side of the disc applies pressure as well, squeezing your disc so the vehicle stops.  Floating calipers are less expensive since they have fewer parts.

The other type is called a fixed caliper.  They use pistons on both sides of the disc, sometimes several.  They are often used in more high-performance or heavy-duty vehicles.

Calipers can have rubber seals to keep out dirt, debris and moisture, but when that rubber wears out, sometimes the calipers can get contaminated.  They can stick or start leaking; they can even rust.  Then your caliper can get stuck applying that "squeeze" when you are not pressing on the brake pedal.  Or they can get stuck in the other position, not applying stopping power when you press the pedal.

When this happens, it's not unusual to feel your vehicle pull to one side when you brake.  You might notice a burning smell from the constant friction if the caliper is stuck on, plus you may feel the heat from the wheel after you park and get out of your vehicle.  Sometimes you'll hear a high-pitched sound or clunk if your calipers are binding up. 

That's your cue to have them checked out at your vehicle service center.  If your calipers aren't working correctly, it can be a safety hazard.  Sticking calipers can affect your ability to steer and stop; this is the kind of "brake time" you need so you can get them back on track and working properly.

Corporate Autoworks
5195 Harvester Rd. Unit#1
Burlington, ON L7L 6E9
905-333-9201
http://www.corporate-autoworks.com

Bad Vibes

Your vehicle has a way of letting you know when something's wrong. Consider a vibrating steering wheel. It certainly didn't do that when it was new, so that shake is trying to tell you something.

There are a few things that can cause your steering wheel to vibrate as you drive down the road.  One of the most common is out-of-balance tires.  You may not only feel that wobble in your steering wheel, you might also feel it in the tires.  Sometimes it's not there when you're driving at lower speeds through residential areas, and sometimes it starts when you hit highway speeds. 

So what is tire balance anyway?  Well, you have a rubber tire that fits around a metal wheel.  It should have the same weight all the way around.  If it doesn't, it will start getting the shakes.  Ever load your washing machine so that all the clothes are at one side of that drum that spins?  When it hits the spin cycle, it can throw that washer against the wall. 

That's the same thing that's happening with an out-of-balance tire/wheel combination.  A technician has special equipment to figure out where to put small weights on the wheel to get things back in balance again.  But it could be that you hit a pothole some time ago and bent the rim.  Or your tire isn't as round and even as it once was.  That could be due to age, damage or wear and tear. The technician will know and offer you options.

Another possibility for that vibrating wheel is a faulty brake, such as warped rotors or a sticky caliper.  All of these issues can be evaluated as part of regular, routine maintenance with us.  There are many things that cause vibrations in your wheels.  But you don't want any bad vibes when it comes to your vehicle.